Skip to content

VM System Requirements#

Supported Versions#

Gluu Flex currently provides packages for these Linux distros:

  • Ubuntu (versions: 20.04 and 22.04)
  • SUSE Distributions
    • SUSE Linux Enterprise Server (SLES) 15
    • openSUSE Leap 15.4
    • openSUSE Tumbleweed
  • RedHat Enterprise Linux (version: 8)

Note

This document is intended exclusively for dev and staging environments. For production deployment on a VM, refer to this documentation which utilizes Rancher and Helm deployments.

Hardware Requirements#

A single-VM deployment is where all services are running on one server. Although, the requirements can vary based on the size of the data and the required concurrency, the following guidelines can help you plan:

  • 4 GB RAM
  • 2 CPU
  • 20 GB Disk

Port Configuration#

Gluu Flex requires the following ports to be open for incoming connections.

Port Protocol Notes
443 TCP TLS/HTTP

You may want to use a redirect on port 80 to 443, although it is not required. Of course you will also need some way to login to your server, but that is out of scope of these docs.

Check your server firewall documentation to configure your firewall to allow https.

Hostname / IP Address Configuration#

It is recommended that you use a static ip address for Gluu Flex. Your server should also return the hostname for the hostname command, it's recommended that you add the hostname to the /etc/hosts file.

File Descriptor Configuration (FD)#

Like most database and Internet servers, you must have at least 65k file descriptors. If you don't, your server will hang.

First, check the current file descriptor limit using command below. If the existing FD limit exceeds 65535, then you're good.

# cat /proc/sys/fs/file-max

If FD limit is less than 65535 (e.g. 1024), then follow the steps below to increase the value.

1) Set soft and hard limits by adding the following lines in the /etc/security/limits.conf file

* soft nofile 65535
* hard nofile 262144

2) Add the following lines to /etc/pam.d/login if not already present

session required pam_limits.so

3) Increase the FD limit in /proc/sys/fs/file-max

echo 65535 > /proc/sys/fs/file-max**

4) Use the ulimit command to set the FD limit to the hard limit specified in /etc/security/limits.conf. If setting to hard limit doesn't work, then try to set it to the soft limit.

ulimit -n 262144

5) Restart the system


Last update: 2024-01-16
Created: 2022-09-22